Calcaneal Fracture ORIF with Lateral Approach, Plate Fixation, and Locking Screws

Preoperative Patient Care
Operative Techniques

Preoperative Plan


Template fracture with radiographs

  • identify fracture pattern based on xrays (AP/Lat/Oblique and Harris/Broden views) and CT scan
  • analyze direction and number of fracture lines (Sanders classification)
  • evaluate joint depression, articular comminution, Bohlers angle, and angle of Gissane
  • if severe articular comminution may need to concurrently fuse subtalar joint
  • if tongue-type with mild displacement and shortening can perform closed reduction with percutaneous pinning
  • goal is to restore calcaneus height, width, alignment, and articular surface


Execute surgical walkthrough

  • describe the steps of the procedure verbally to the attending prior to the start of the case
  • describe potential complications and steps to avoid them

Room Preparation


Surgical instrumentation

  • Calcaneus Plating System (Stryker Veriax Calcaneus System)


Room setup and equipment

  • standard OR table with radiolucent end
  • c-arm in from contralateral side end of bed at ~20° to get Harris heel view


Patient positioning

  • patient lateral decubitus on beanbag with feet at end of bed
  • place sheets between ipsilateral and contralateral extremities to make elevated flat working surface ~1’ in height
  • make sure body and legs are taped down (need flat surface to work on)
  • can alternatively place patient supine with table tilted away from surgeon
  • thigh tourniquet placed high on thigh with webril underneath

Lateral Approach to Calcaneus


Mark out lateral malleolus and lateral border of Achilles

  • exsanguinate limb and inflate tourniquet


Start incision 2-4 cm proximal to lateral malleolus on the posterior border of the fibula

  • extend incision down posterior fibula and bend around lateral maleolus over the peroneal tubercle
  • curve distally to a point 4 cm inferior and 2.5 cm anterior to lateral malleolus
  • follow the course of the peroneal tendons


Mobilize skin flaps

  • be careful to avoid sural nerve and short saphenous vein that run posterior to the lateral malleolus


Expose the peroneal tendons

  • incise the deep fascia to uncover the peroneal tendons
  • incise the inferior peroneal retinaculum over peroneus brevis
  • must repair at end of case to prevent dislocation
  • incise sheath of peroneus longus
  • mobilize peroneal tendons and retract them anteriorly over the lateral malleolus

Deep dissection


Identify calcaneofibular ligament and incise

  • locate the posterior talocalcaneal joint capsule and incise it transversly
  • inverting the foot will expose the articular surface
  • to expose lateral surface of calcaneus perform subperiosteal dissection inferiorly


Isolate peroneal tendons

  • divide superficial and deep fascia
  • if necessary and there is no infection may divide tendons by Z-plasty and repair at end of case


Perform subperiosteal dissection

  • incise and elevate the periosteum below the tendons
  • subperiostally elevate tissues (including tendons) superiorly and inferiorly off the lateral surface of the calcaneus


Use “no touch” technique avoiding skin using three .062 kwires into ant/med/post aspect of talus

  • bend kwires with driver into two 90° angles as fixed internal retractors for subcutaneous and skin retraction

Bony Preparation


Identify the fracture lines

  • delineate fracture lines with knife and clean out using freer, curettes, and rongeur


Identify the fracture fragments

  • identify lateral wall that is often broken off, remove piece, clean and mark orientation for later use, and place in saline on back table
  • next find constant anteromedial fragment and build off of it
  • check to see how remaining fragments fit together
  • break apart fragments with curved osteotome and lever to regain calcaneus height
  • identify if there is a central void of comminution due to bone loss



Restore ant/med/post facet of subtalar joint

  • remove fragments if needed and temporarily pin into place with multiple kwires
  • use kwires to join pieces together
  • check Bohlers angle and angle of Gissane with fluoro
  • use kwires through bottom of calcaneus to pin constant fragment to remaining fragments


Place large shantz pin

  • drill large Shantz pin into posteroinferior aspect of calcaneus perpendicular to bone to gain traction through fragment
  • use bolt cutter to remove sharp end, T-handle to apply traction through pin and distract fragments


Reduce the periphery of the calcaneous

  • build periphery of calcanues and later fill in central void with allograft chips, tamp in gently


Check AP/Lat/Harris fluoro to check calcaneus reduction in terms of height, width, alignment, and articular surface

  • use blue handle of lap around forefoot to pull foot into dorsiflexion for heel view



Place lag screw

  • use a 3.5mm lag screw to join largest pieces lateral to medial (2.7mm drill, 3.5mm screws)
  • be careful of iatrogenic injury to FHL from long screws


Check calcaneus plate sizing on Lat fluoro


Fill central void of the calcaneous

  • use bone chips allograft, then place lat wall fragment back into place


Fix the plate to the calcaneous

  • first place bicortical nonlocking screws into the anterior and posterior aspects of plate to compress plate down to bone
  • check position on fluoro


Place locking screws around periphery of plate

  • check on heel and Lat xrays
  • if performing simultaneous fusion of subtalar joint, place threaded guidepins for 8.0mm cannulated screws x2 through posterior facet of subtalar joint
  • use heel view 2cm apart for placement
  • check on fluoro Lat for placement into talar body
  • measure, drill calcaneus cortex, just into talar body
  • place screw on power followed by hand
  • can use fully threaded (if significant comminution of subtalar joint) or partially threaded screws (for compression)
  • confirm hardware position


Check with fluoro on AP/Lat/Harris views

  • exchange screws that are too long medially to avoid tendon irritation (FHL) and damage

Wound Closure


Irrigation, hemostasis, and drain

  • irrigate wounds thoroughly and deflate tourniquet
  • cauterize any bleeders carefully, watching out for saphenous vein
  • hemovac drain deep exiting superolateral from incision



  • subcutaneous closure with 2-0 vicryl
  • skin closure with 3-0 nylon horizontal mattress or Allgower-Donati stitch to reduce skin tension (diabetics, smokers)


Dressing and immediate immobilization

  • dress the incision(gauze, webril) followed by postmold splint with extra padding under heel for immobilization
  • crutches or walker for ambulation
Postoperative Patient Care

Topic COMMENTS (0)
Private Note