Single Level Lumbar Decompression and Fusion (PLIF)

0%
TECHNIQUE VIDEO
0%
TECHNIQUE STEPS
 
0
0
TECHNIQUE STEPS
Preoperative Patient Care
Operative Techniques
D

Simulation

1

Accurately identifies anatomic landmarks

  • Origin of ligamentum flavum
  • Pars
  • Superior facet
  • Inferior facet
  • Descending nerve root
  • Exiting nerve root

2

Performs wide decompression

  • Demonstrates manual skills with reongeur and kerrison
  • Demonstrates use of high-speed burr on bone substitute

3

Inserts pedicle screws

  • Identifies starting point landmarks
  • Correctly measures length
  • Understands average pedicle diameter and medial inclination
  • Checks medial border of pedicle with probe for breach
  • Places pedicle screws and rods
E

Preoperative Plan

1

Identifies area of decompression on preoperative imaging

2

Template instrumentation on preoperative imaging studies.

3

Execute surgical walkthrough

  • resident describes steps of the procedure verbally prior to the start of the case
  • list potential complications and steps to avoid them
F

Room Preparation

1

Surgical instrumentation

  • Lumbar Instrumented Fusion System
  • Interbody fusion device
  • Autologous or allograft bone for fusion

2

Room setup and equipment

  • table
  • radiolucent Jackson spine flat top table
  • neuromonitoring
  • neuromonitoring leads to upper and lower extremities
  • C-arm
  • c-arm perpendicular to table
  • microscope
  • microscope in from opposite side of C-arm

3

Patient positioning

  • prone with arms at 90° max abduction and flexion to prevent axillary nerve injury
  • foam padding on chest so that nipples are pointing midline straight down
  • pads over ASIS and gel pads on knees
  • foley in place
  • bilateral TED hose and SCDs
G

Superficial Dissection to Expose Spinous Process

1

Localize level of incision with anatomic or radiographic landmarks

2

Make midline incision.

  • midline incision with 10blade overlying the spinous processes between paraspinal muscles (erector spinae)
  • ~3-4cm in length for single level

3

Dissect subcutaneous tissue down to fascia

  • insert cerebellar retractors x2 for fascial exposure

4

Cauterize lumbodorsal fascia over spinous processes to just lateral of midline

H

Deep Dissection to Expose Transverse Processes

1

Perform subperiosteal dissections

  • use Cobb along spinous processes
  • perform subperiosteal dissection of lamina from a cranial to caudal direction

2

Place probe under lamina to identify level radiographically

3

Expose the facet capsules

  • use Cobb to strip laterally along lamina until facet capsules exposed

4

Dissect out transverse process

  • dissect paraspinal muscle from intertransverse membrane

5

Place deep retractors for better visualization

I

Laminectomy and Central Decompression

1

Remove spinous processes of operative levels with rongeur

  • save as bone graft for fusion

2

Remove lamina and identify origin of ligamentum flavum

  • begin with decompression into canal into inferior half of lamina of cephalad vertebrae first with small curette
  • burr lamina and to thin and then complete resection with Kerrison rongeurs

3

Resect ligamentum flavum

  • gently retract ligamentum flavum with woodsen elevator
  • resect remaining lamina and ligamentum with Kerrison rongeur of cephalad vertebrae
  • resect ligamentum from superior lamina of inferior lamina
  • use Kerrison to resect caudad lamina from inferior vertebra
  • use woodsen to protect dura and nerve roots during entire resection of ligamentum flavum
J

Lateral Recess and Foraminal Decompression

1

Perform Medial facetectomy

  • Decompress medial aspect of facet on each side (2-3 mm of medial facet)

2

Decompress lateral recess

  • locating pedicle key to safe decompression
  • kerrison to undercut medial edge of superior facet of caudad vertebra until medial edge of pedicle visualized
  • identify osteophytes that could impinge exiting nerve root around pedicle
  • undercut remaining superior facet using kerrison rongeur
  • if not fusing no more than 50% superior facet should be resected

3

Confirm exiting and descending nerve roots are well decompressed

  • descending nerve root should be visualized

4

Check to make sure no disc herniation.

  • Dural sac/nerve root may be retracted to see if there is bulging disc is present
K

Interbody Arthrodesis (PLIF)

1

Retract dura and place introducer into disc space

  • confirm position with fluoroscopy

2

Clear endplates

3

Place interbody device

L

Pedicle Screw Placement & Instrumentation

1

Identify and prepare starting point.

  • landmark for pedicle screws is inferolateral aspect of the intersection of facet and transverse process
  • for sacrum landmark is base of facet at S1 (superolatral to sacral foramen)
  • decorticate entry site with burr

2

Place pedicle finder and confirm intra-osseous position

  • place gearshift probe into pedicle track ~30mm until significant resistance is felt (anterior cortex of vertebral body)
  • insert balltip probe to check floor, medial, inferior walls of pedicle
  • check for canal/nerve root
  • once markers confirmed in correct locations advance gearshift 40-50mm

3

Insert pedicle screws

  • identify proper length
  • tap 5mm and recheck with balltip probe
  • insert pedicle screws (i.e. L4, 6.5x50mm screws; L5, 7.5x40mm screws)

4

Confirm proper position of pedicle screws with radiographs

  • confirm position of radiographs with AP and lateral imaging

5

EMG (optional)

  • EMG test all screws to ensure no pedicle wall breach

6

Place rods and finalize instrumentation

  • place 2 contoured rods (i.e. 6.0mm rods, use hand benders) for desired lordosis into screw tulips
  • insert set screws
  • place any final distraction/compression and lock set screws
N

Prepare Arthrodesis and Wound Closure

1

Decorticate transverse process to faciliate posterolateral fusion

  • decorticate surrounding transverse processes, facet joints, and pars with burr

2

Pack posterolateral gutters with autologous/allograft graft (performed after pedicle screws and rods are placed)

3

Irrigation and hemostasis

  • flush out spine with saline bulb irrigation
  • can use betadine wound lavage or vancomycin powder to decrease infection risk
  • obtains appropriate hemostasis
  • use Floseal for hemostasis

4

Place hemovac drain under fascia

5

Close Fascia

  • close fascia with 0-vicryl
  • need water tight closure and need to decrease dead space for hematoma

6

Superficial closure

  • subcutaneous with 2-0 vicryl
  • skin closure with buried 3-0 monocryl

7

Dressing

  • soft incision dressings over spine
Postoperative Patient Care
 

Please rate topic.

Average 4.0 of 9 Ratings

Topic COMMENTS (0)
Private Note