• ABSTRACT
    • The semiconstrained design of the reverse arthroplasty allows loads from the humerus to challenge the fixation of the glenoid component to the scapula. We examined some of the factors affecting the quality of glenoid screw fixation, including the density of the material into which the screws are placed, the purchase of individual screws, and the direction of loading in relation to screw placement. Loads were applied by the humeral component to glenoid components with different conditions of fixation. The load to failure for each set of conditions was measured and compared statistically. Load to failure was less when the glenoid component was fixed to material of lesser density. Each screw contributed to the quality of fixation; the screw nearest the point of load application made the largest contribution. Load to failure was less when the load was colinear with a line through the nonlocking holes in the base plate compared to colinear with a line through the locking holes. In performing a reverse total shoulder, surgeons should emphasize secure intraosseous placement of the fixation screws in the best quality bone available. The placement of the inferior screw appears to be the most critical.