Please confirm topic selection

Are you sure you want to trigger topic in your Anconeus AI algorithm?

Please confirm action

You are done for today with this topic.

Would you like to start learning session with this topic items scheduled for future?

Surgical Treatment of Cavus Foot

Preoperative Patient Care
Operative Techniques
E

Preoperative Plan

1

Examine subtalar motion under anesthesia

2

Execute a surgical walkthrough

  • describe steps of the procedure to the attending prior to the start of the case
  • describe potential complications and steps to avoid them
F

Room Preparation

1

Surgical instrumentation

  • oscillating saw
  • 1/4 inch and 1/2 inch osteotomes
  • 1.6 mm and 2.0 mm smooth steinmann pins
  • Chandler retractors
  • Hohman retractors

2

Room setup and equipment

  • standard OR table

3

Patient positioning

  • supine
  • place a bump under the ipsilateral hip for internal rotation of the foot
G

Plantar Release

1

Make the skin incision

  • make a longitudinal incision medially of the plantar fascia

2

Perform dissection

  • use sharp knife dissection through the skin and the subcutaneous fat

3

Expose the deep fascia

  • identify and release the abductor hallucis off of the deep fascia
  • expose the fascia that is deep to the abductor hallucis

4

Identify the neurovascular structures

  • identify the posterior tibial nerve and artery proximally
  • follow distally by releasing the overlying fascia

5

Expose the plantar fascia

  • expose the plantar fascia where it attaches to the medial tubercle of the calcaneus

6

Release the tendons

  • use Mayo scissors to release the flexor digitorum brevis, quadratus plantae and the abductor digiti quinti muscles at the their proximal origins

7

Loosely close the wound

  • close the wound loosely with interrupted sutures to allow drainage of blood for prevention of hematoma
H

Proximal Dorsal Based Oblique Closing Wedge Osteotomy (Medial Column Osteotomy)

1

Make the skin incision

  • make a longitudinal incision over the proximal metatarsal
  • be careful to protect and identify the dorsal digital nerve

2

Perform subperiosteal dissection of the proximal metatarsal

  • be sure to leave the plantar periosteum and soft tissue intact

3

Place pins

  • place 2 small diameter Steinmann pins with a drill at the site of the bone cuts
  • these pins should converge at the plantar apex
  • the apex of the cut should be very proximal and plantar

4

Perform the osteotomy

  • use a small oscillating saw to make the cuts
  • use the wires as guides for the cuts

5

Remove the cut bone

  • use a small osteotome and rongeur to remove some of the bone at the apex
  • leave a bony and soft tissue hinge intact so that this is an incomplete closing wedge osteotomy

6

Reduce the osteotomy

  • slowly close the ends together while maintaining the bone hinge

7

Apply fixation

  • secure the osteotomy with a wire, screw or dorsal plate

8

Close the wound

  • close the wound with loose interrupted sutures
I

Interphalangeal Joint Fusion (Modified Jones Procedure)

1

Make a transverse incision

  • make a transverse incision over the interphalangeal joint of the great toe

2

Expose the articular surface

  • carry the incision down to the extensor hallucis tendon
  • transect the tendon at the level of the IP joint
  • transversely incise the joint capsule
  • continue with a no. 15 blade to expose the articular distal aspect of the proximal phlanx

3

Remove the articular surface

  • use a rongeur to remove the articular cartilage and a small amount of subchondral bone on both sides of the IP joint

4

Place a guidewire

  • place a guidewire in a retrograde fashion through the center of the distal phalax so that it exits distally just plantar to the nail

5

Reduce the joint

  • reduce the joint in a neutral position

6

Place fixation

  • insert the screw
  • provide compression at the IP joint
  • the proper length will place the tip of the screw into the proximal aspect of the proximal phalanx

7

Close the wound

  • close the wound with loose interrupted sutures
J

Transfer of the EHL Tendon to the Metatarsal Neck (Modified Jones Procedure)

1

Make the skin incision

  • make a longitudinal incision over the distal first metatarsal

2

Expose the EHL

  • identify and isolate the extensor hallucis tendon
  • this should be done until its cut end can be pulled into the incision

3

Prepare the EHL

  • place a 0 whipstitch suture into the distal tendon

4

Expose the distal metatarsal

  • subperiosteally expose the distal metatarsal

5

Prepare the metatarsal neck

  • make a transverse drill hole in the metatarsal neck
  • the drill diameter should be the same diameter as the extensor hallucis tendon

6

Pass the tendon

  • pass the tendon with the assistance of wire or suture passer

7

Secure the tendon

  • after the appropriate osteotomy is reduced and final fixation has been placed, secure the EHL to itself

8

Close the wound

  • close the wound with loose interrupted sutures
K

Midfoot Osteotomy

1

Make the skin incision

  • make a long dorsomedial skin incision at the apex of the deformity

2

Place the retractors

  • place hohmann retractors dorsally and plantarly to expose the entire midfoot

3

Place Steinmann pins

  • insert smooth Steinmann pins to define the proximal and distal aspects of the osteotomy

4

Perform the osteotomy

  • make the osteotomy with an oscillating saw
  • complete the osteotomy with rongeurs
  • remove a dorsal based wedge

5

Reduce the osteotomy

6

Place fixation

  • place two threaded Steinman pins for fixation

7

Close the wound

  • close the incision with loose interrupted sutures
L

Calcaneal Osteotomy

1

Make a lateral oblique skin incision

  • make a lateral oblique incision just posterior to the peroneal tendons

2

Identify the fibulocalcaneal ligament

  • section this ligament along with the periosteum

3

Use an oscillating saw to perform osteotomy

  • create a laterally based wedge on the calcaneus
  • this should be immediately posterior to the peroneus longus tendon

4

Close the wedge

5

Perform fixation

  • fixation of the wedge can be performed with a Steinmann pin or cannulated 7.3 mm screw
  • introduce the screw percutaneously in the trajectory that is perpendicular to the osteotomy
N

Immobilization

1

Place in a non weightbearing cast

  • leave in place for 4 weeks
Postoperative Patient Care
Private Note

Attach Treatment Poll
Treatment poll is required to gain more useful feedback from members.
Please enter Question Text
Please enter at least 2 unique options
Please enter at least 2 unique options
Please enter at least 2 unique options