Please confirm topic selection

Are you sure you want to trigger topic in your Anconeus AI algorithm?

Please confirm action

You are done for today with this topic.

Would you like to start learning session with this topic items scheduled for future?

First MTP Joint Arthrodesis

Preoperative Patient Care
Operative Techniques
E

Preoperative Plan

1

Template arthrodesis with radiographs

2

Execute surgical walkthrough

  • describe the steps of the procedure verbally to the attending prior to the start of the case
  • describe potential complications and steps to avoid them
F

Room Preparation

1

Surgical instrumentation

  • MTP plating system

2

Room setup and equipment

  • standard OR table with radiolucent end

3

Patient positioning

  • supine position with a bump under the ipsilateral buttock
G

Joint Exposure

1

Mark a dorsolateral incision

  • center the dorsolateral incision over the first MTP joint in the interval between the medial and lateral common digital nerves

2

Extend the incision

  • span the incision from a point just proximal to the IP joint of the hallux to 3 to cm proximal to the MTP joint
H

Deep Dissection

1

Expose the synovium

  • deepen the dissection along the medial aspect of the EHL tendon through the extensor hood and the joint capsule
  • perform a thorough synovectomy

2

Inspect the MTP

  • locate osteophytes and loose bodies
  • determine the extent of articular damage
I

Joint Resection and Decompression

1

Remove the articular surface

  • remove a thin section of articular surface from the distal first metatarsal and proximal phalanx with a sagittal saw

2

If shortening required

  • resect more bone from the metatarsal head
  • use a sagittal saw to resect the medial eminence
J

Metatarsal Head Preparation

1

Place K-wire

  • drive a 0.062 K wire in a proximal direction at the center of the metatarsal head

2

Determine the appropriate reamer

  • compare the diaphyseal width of the metatarsal with the inner width of the reamer

3

Prepare the canal

  • engage the power reamer with the K wire
  • drive the K wire in a proximal direction
  • shave the metatarsal subchondral surface and metaphysis to the cup shaped convex surface
  • remove any excess bone along the periphery with a rongeur

4

Increase the surface area for arthrodesis

  • remove the K-wire
  • use the K-wire to perforate the prepared metatarsal head in multiple places to increase the surface area for arthrodesis
K

Proximal Phalangeal Preparation

1

Place the K-wire

  • center a 0.062 K-wire on the base of the proximal phalanx
  • drive the K-wire distally

2

Prepare the surface

  • use the smallest convex cannulated phalangeal reamer to prepare the surface
  • use larger reamers to enlarge the phalangeal surface so that it matches the size of the prepared metatarsal surface

3

Remove the K-wire

4

Increase the surface area of the joint surface

  • collect cancellous bone shavings throughout the entire process and place in a small cup to place in between the prepared surfaces
L

Joint Alignment and Internal Fixation

1

Place autograft

  • place the autograft between the joint surfaces
  • coapt the cancellous joint surfaces to the desired amount of varus, valgus, doriflexion, plantarflexion and rotation

2

Place the joint in the appropriate position

  • the optimal position is 20 to 25 degrees of dorsiflexion , 10 to 15 degrees f valgus and neutral rotation
  • all angular measurements relate the axis of the first metatarsal shaft

3

Place provisional fixation

  • temporarily stabilize the arthrodesis site with 1 or 2 crossed 0.062 K-wires

4

Apply the plate

  • use a rongeur to smooth the the dorsal aspect of the first metatarsal and proximal phalanx to allow the plate to sit flush on the bone

5

Place Screws

  • place bicortical self-tapping screws to fix the plate to the metatarsal
  • use locking screws in the instance of osteopenic bone
  • fix the plate to the proximal phalanx with a screw placed in compression
  • remove the K-wire
  • place a cross-compression screw to augment the fixation construct
N

Wound Closure

1

Irrigation and Hemostasis

  • copiously irrigate the wound

2

Close capsule

3

Superficial wound closure

  • use 3-0 vicryl for subcutaneous tissue
  • use 3-0 monocryl for skin

4

Dressing

  • wrap the foot in a gauze and tape compression dressing after surgery
Postoperative Patient Care
Private Note

Attach Treatment Poll
Treatment poll is required to gain more useful feedback from members.
Please enter Question Text
Please enter at least 2 unique options
Please enter at least 2 unique options
Please enter at least 2 unique options